| Previous Page |
Next Page |
| Testing Index | On-Line
Catalog |
1-800-662-6099
Catalog - Page 63
STARTER TESTER
- Fully automated precise testing for high volume applications at the touch of a button
- Load test units up to 50 Nm (optional 75 Nm) with improved accuracy
- Optional free run speed sensor and Solenoid Block Test
- Reject bin input, marking device output, very fast change over time, automatic clamping , connections, learning mode to create new test profiles, real time statistical monitoring, safety lever IV protection, programmable installation and setup instructions, and serial number support
- Measures more than 40 different starter parameters including; performance curve with load, free spin current and speed, solenoid current, contact voltage drop, and "R" terminal function
- User configurable Labels, Pass and Fail reports with performance curve plotting torque, power, speed, and voltage
- Computer controlled programmable 1600 Amp starter power, simulating 200-2000 CCA battery (0-30 milliohms)
- Computer controlled 150 Amp programmable solenoid power supply, solenoid pull-in can be tested at a programmable reduced voltage during the test to insure operation under worst case conditions
- Load test conditions can include speed, torque, current, power and voltage
- Tests starter, solenoid, drive, and spring engage and disengage timing, this can reveal faulty components or assembly errors
- Built-in oscilloscope, precise waveform analysis which can detect armature, commutator and brush problems
- Programmable solenoid "aging" function to seat the solenoid contact
- Can scan a full performance curve in 12 seconds which increases the accuracy by decreasing test result variation caused by temperature change
- Supplied with flat touch screen color LCD monitor
- Available in many working voltages (220 to 480V at 50/60 Hz)
- Engine firing simulation
- Built in endurance test capabilities
- Test data logging with graphical display of test cycle for analysis
- Optional light curtains for added safety protection
Specifications:
- Starter Current: up to 1600 Amps
- Starter Voltage: 12 & 24 Volts (32V optional)
- Starter Speed: 0-20,000 RPM
- Starter Torque: up to 50 Nm (optional 75Nm)
- Solenoid Current: up to 150 Amps
- Contact Voltage Drop: 0-2.5 Volts
- Starter Efficiency: 0-100%
- Starter Output Power: average 3.0 to 4.0 kW
- Starter Input Power: up to 20 kW
- Ripple Current: 0-200 Amps
| Previous Page | Next Page |
| Testing Index | On-Line Catalog |
1-800-662-6099
Catalog - Page 63