Previous Page
 Next Page
Press Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 96
M155-0025
PRODUCTION ARMATURE RESHAFTING TOOLING

•    Order piece by piece
•    Hardened steel makes this tooling last through high production conditions
•    The design of this tooling will provide you with the lowest fall out ratio of any tooling available
•    Picture shows step by step shaft removal & installation
•    Four pieces are needed for removal
•    One additional piece is needed for installation in most applications
•    Must specify armature

For Shaft Removal - the following pieces are needed
Commutator vise = M155-0025-V, with application
Reshafting sleeve = M155-0025-S, with application
Adjustable base cup = M155-0025-C, with application
Press plate = M155-0025-PP, with application

Note:  a different reshafting sleeve is needed for each
armature application

For Shaft Installation - the only additional tooling is
Drive end shaft bushing = M155-0025-DSB, with application
Adapter ring = M155-0025-A, only need for limited applications
A452-0001
ROTOR REBUILDING TOOLING

ROTOR RESHAFTING TOOLING
A452-0001 + APPLICATION

•    Remove & install the shaft
•    Position the slip rings
•    Clamp the pole pieces in place
•    5 piece set
•    Must specify application

Press required: 20 Ton
A452-0002
POLE PIECE STAKING TOOLING
A452-0002 + APPLICATION

•    Stake the pole pieces tight against the rotor shafts
•    Insure a better contact between the pole piece and the center slug
•    2 piece set
•    Must specify application

Press required:  20 Ton
A452-0003
POLE PIECE EXPANDER TOOLING
A452-0003 + APPLICATION

•    Increase output & reduce cut in RPM
•    Spread out the rotor claws on a disassembled rotor to decrease the air gap between the rotor the the stator
•    Rotor pole pieces must be remachined after assembly
•    2 piece set
•    Must specify application
Previous Page Next Page
Press Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 96