| Previous Page |
Next Page |
| Winding Index | On-Line
Catalog |
1-800-662-6099
Catalog - Page 141
M155-0142
MANUAL STATOR CUTTER
MANUAL STATOR CUTTER
Operation:
1 Mount the stator over the arbor
2 Push handle and cutting knife cuts trough the coil groups
3 Handle is returned by spring action
4 Rotate and cut until cycle is complete
Complete with arbor & knife
Production rate: cut as many as 80 stators per hour
Tooling change time: less than 5 minutes
Replacement Parts:
M155-0142-A Arbor per application
M155-0142-K Knife per application
M155-0016
PRODUCTION STATOR CUTTING MACHINE, ELECTRO PNEUMATIC POWERED
• Cut’s one sidePRODUCTION STATOR CUTTING MACHINE, ELECTRO PNEUMATIC POWERED
• Stator rotates at 200 RPM
Operation:
1 Mount the stator
2 Activate the control button
3 The machine rotates and cuts the lower side off and discharges out the right side
Production rate: up to 250 stators per hour
Tooling change time: less than 10 minutes
Air required: 150 psi clean, dry
Power:
Motor = 3/4HP, 110/220V, 1 Phase, 60Hz
Controls = 110V
Tooling sold separately:
M155-0016-T Tooling per application, samples required
| Previous Page | Next Page |
| Winding Index | On-Line Catalog |
1-800-662-6099
Catalog - Page 141