| Previous Page |
Next Page |
| Winding Index | On-Line
Catalog |
1-800-662-6099
Catalog - Page 146
C755-0600-JCP
PNEUMATIC STATOR WIRE ID FORMER
PNEUMATIC STATOR WIRE ID FORMER
With
one set of tooling
Prevent the rotor from dragging on the stator wires by forming the stator wire ID to the correct tolerance.
• Stop the line rejects before they start
• Adjustable Pressure Regulator/Filter
• Powerful 3” Pneumatic Cylinder
• Requires 120 psi air supply
• Additional tooling $450.00 each
• Custom tooling available, sample required
Production rate: up to 250 pieces per hour
Tooling change time: less than 2 minutes
M155-0221
PENUMATIC STATOR FORMING MACHINE
PENUMATIC STATOR FORMING MACHINE
• Forms inside and outside clearance of the stator windings prior to final forming
• Final height forming may still be necessary, see M155-0021-FF Stator Height Forming Fixture below
• Forming dies are covered for maximum safety
Operation:
1 Place the stator in the forming fixture
2 Activate the foot switch
3 Rotate until forming is complete
Production rate: as many as 150 per hour
Tooling change time: less than 5 minutes
Power: 150 psi, clean dry air
Tooling sold separately: M155-0021-TA specify application
Samples required for tooling
M152-0021-SFF
STATOR HEIGHT FORMING FIXTURE
STATOR HEIGHT FORMING FIXTURE
Forms
the coil height to insure proper rotor and housing clearance
Operation:
1 Mount fixture with center pilot in place on press
2 Put stator already preformed inside and outside of the coils in the fixture with the leads coming out the slot.
3 Mount the top plate over the center pilot
4 Slide under the press ram and press
Press sold separately, press recommendation:
M152-0021-2 Air Press, see press section
M152-0021-H5 Hydraulic Press, see press section
| Previous Page | Next Page |
| Winding Index | On-Line Catalog |
1-800-662-6099
Catalog - Page 146