Previous Page
 Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 275
B358-0470-before
B358-0470-done
SNAP RING INSTALLING & SEATING TOOLS

B358-0470   
5 & 10MT, SD, BOSCH 108-110, FORD PMGR & MORE, .470
B358-0560   
20-27MT, 30-35MT, 37MT, 10MT INDUSTRIAL, BOSCH HD & MORE, .560
B358-0670   
LUCAS M127, M50 NIPPON, 4.0kW INDUSTRIAL, FORD 6.9-7.3, .670

Operation:
1    Install snap ring and retainer
2    Slip open end of pliers over the armature
3    Align shaft with hole in the other end
4    Squeeze.  When pliers close, snap ring and retainer are loaded

When installing snap rings, adjust the lock nut so minimal pressure is exerted.  On 10MT’s use 76-1803 thrust washers, on 27MT’s use 76-848 or W with cleaned out center.  This will help with the stubborn ones.
B358-1600-before
B358-1600-done
B358-1600
SNAP RING INSTALLER

•    Covers shafts from approximately .488 to .560

Operation:
1    Place bullet on the drive end of the armature
2    Push lock ring over bullet
3    Press into position with the Palm Tool

Service Parts:
B358-1600-1  Palm Tool
B358-1600-2  Bullet
H108-0142-T
STOP COLLAR/LOCK RING UNSEATER

H108-0142-T    10MT
H108-0143-T    27, 30 & 35MT

Separates collar from slip ring
H108-0155-T
H108-0155-T
DELCO SNAP RING POSITIONER

•    Application:  10MT
•    Quickly installs the snap ring in the exact position in the groove
Previous Page Next Page
Tools Index On-Line Catalog
VENSEL ENTERPRISES
1-800-662-6099
Catalog - Page 275