| Previous Page |
Next Page |
| Tools Index | On-Line
Catalog |
1-800-662-6099
Catalog - Page 276
C758-0752
Snap Ring Removing Tool
(Vice or Bench Mounted with the two 3/8” holes)
Snap Ring Removing Tool
(Vice or Bench Mounted with the two 3/8” holes)
Our new Snap Ring Remover removes most snap rings. Snap Rings have always been a favorite part of the rebuilding process. They are probably the biggest cause of self-inflicted injuries in the rebuilding process. Here is a new approach that will removed snap rings from multi-size shaft and snap rings. This tool is adjustable for snap rings from 1/4” (6.3mm) to 7/8” (22.2mm). The C758-0752 can be used right side up or upside down. NO ICE PICKS OR SHARP SCREW DRIVERS!!!
• V-Groove is for most snap ring retainer removal
• U-Slot is for shaft insertion behind snap ring
• Stripper Jaws are hardened tool steel for stripping the snap ring from it’s groove
• Back Jaw are made of hardened tool steel and can be turned over or flipped end to end, giving 4 sharp surfaces to use.
• Side Jaws are hardened tool steel and can be flipped over or end to end giving you 4 sharp surfaces to use.
Additional Tools Required:
- 3/16” Allen Wrench
- Soft Face Hammer
- Vice
| Previous Page | Next Page |
| Tools Index | On-Line Catalog |
1-800-662-6099
Catalog - Page 276