| Previous Page |
Next Page |
| Tools Index | On-Line
Catalog |
1-800-662-6099
Catalog - Page 281
M158-0231
AIR/HYDRAULIC ALTERNATOR STATOR PULLER
AIR/HYDRAULIC ALTERNATOR STATOR PULLER
Features:
• Designed to remove press fit stators from the alternator housings
• easily adjustable, support plates to center & hold housing
• Dual palm button controlled
• No tooling required to pull stators
• Based on stator ID of 2.73” to 4.41”
Air required: clean dry shop air, 120 psi
Production time: approximately 3 per minute
Change over time: approximately 5 minutes from one stator size to another
Size: 36”D x 16”W x 30”H
Weight: 150 lbs.
 |
 |
CS130D STATOR INSTALLING KIT
•
By using this kit containing the C508-8000
Stator Installing Tool and the C508-8001
CS130D Housing Holding Fixture,
you end up with one of the most accurate means of installing the
popular CS130D stator.
• The tooling is centered in the housing with the long shaft that goes through either the 6203 or 6303 drive end bearing
• The tooling is centered in the housing with the long shaft that goes through either the 6203 or 6303 drive end bearing
A158-3132
CS130 STATOR ASSEMBLY FIXTURE
• Press the stator into the drive end housing
• Used with an arbor press
| Previous Page | Next Page |
| Tools Index | On-Line Catalog |
1-800-662-6099
Catalog - Page 281